工程建設的擴建，讓越來越多的材料有了廣泛的應用，濟南泡沫復合板就是使用效果和頻率都比較好的材料，在施工時復合板要有正確的施工方法，注意一些相關的事項，這樣才能保證整個工程的順利進行。那么，泡沫復合板在施工中需要注意什么呢，為了能讓材料使用的更加長久需要怎么儲存呢，帶著這些問題，我們一起來了解下。

More and more materials have been widely applied in the expansion of engineering construction. The Ji'nan foam composite board is a good material with good effect and frequency. During construction, the correct construction method should be applied to the composite board and some related matters should be noticed, so as to ensure the smooth progress of the whole project. So, what should we pay attention to in the construction of foam composite panels? In order to make the materials used more long, how to store them?

濟南巖棉泡沫板 施工注意什么？

Ji'nan rock wool foam board construction pay attention to what?

1、要注意防雨，不能在雨天施工，復合板用于保冷要在加防潮層，在溫度特殊低的狀況下，其防潮層也需要防火的

1. It is necessary to pay attention to rain proof. It is not allowed to construct in rainy days. When composite board is used for cold insulation, damp proof layer should be added. In case of special low temperature, its damp proof layer also needs to be fireproof

當溫度超過的溫度，比如：200℃時，保溫加適宜的外護，這樣就不會使它的厚度和容重發生轉變

When the temperature exceeds the temperature, such as 200 ℃, the insulation plus appropriate external protection, so that its thickness and bulk density will not change

2、保溫的設備，保溫釘以及管道為利于防腐，可接納恰當涂層。另外應沒有任何走漏的地方。這樣可以達到好的效果。隔熱設備，絕緣釘和防腐蝕管，可以適當接受涂層。此外，應該沒有泄漏的地方。這可以實現好的效果。

2. Insulation equipment, insulation nails and pipes may accept appropriate coating for corrosion protection. In addition, there should be no leakage. This can achieve good results. Insulation equipment, insulation nails and anti-corrosion pipes can be properly coated. In addition, there should be no leakage. This can achieve good results.

成品在室外保溫的情況下易受機械磨損的應宜用金屬或塑料包皮，然后留意接頭的地方，接縫的密封，需要時加膠質封條，包裹層堆疊局部不小于100毫米。

If the finished product is easy to be mechanically abraded under outdoor thermal insulation, metal or plastic wrapping should be used. Then pay attention to the joint position and joint sealing. If necessary, glue seal should be added. The stacking part of the wrapping layer should not be less than 100 mm.

當保溫對象呈90度放置，且有的高度時保溫要有定位銷或支承環，間距不要大于3米，以防保溫資料在有震動時向下滑動。

When the insulation object is placed at 90 degrees and some height, the insulation should be provided with positioning pin or supporting ring, and the spacing should not be greater than 3 meters, so as to prevent the insulation material from sliding downward in case of vibration.